Switching into Commander Mode on a 2B

In order to use the Digital Link Interface with Commander3, UpLink or E-Stim Connect you need to switch Commander on on the 2B. If you are running the latest firmware 2.106, then this process is NOT required, as your 2B will automatically switch into Commander Mode when required.

 

These are the steps for 2B firmware 2.105 or older.

 

Step 1.

 

Switch your E-Stim Systems 2B on. once the 2B has gone through its self-check process you should see a screen similar to this;

 

commander off
  

 

Step 2.

 

Double Press Select in order to get into the mode select display.

 

mode select

 

 

 

Step 3.

 

Rotate the adjust knob so the display shows 

 

mode commander

 

 

 

 

 

 

 

22 Commander. The bottom line will be moving.

 

 

 

Step 4

 

Press Select, you should now see the select option display

 

select commander off

 

 

 

Step 5

 

Now rotate the adjust knob to show Commander:On

 

select commander on

 

 

 

Step 6

 

Now press Select. At this point Commander is not yet switched on. You should now see an arrow on the bottom line of the display on the 2B.

 

commander on

 

 

 

 

 

 

 

This indicates Commander on the 2B is now active. Now you can plug in the Digital link interface cable.